Description
Reusable Silicone Tap Hole Template – 32mm – EuroForm for 32mm tap hole diameter. For “EuroForm” edge profiles only.
Silicone tap hole template for a 32mm (1 ¼”) tap hole. Fits most standard taps. For use with the narrower thinner “EuroForm” edge profiles and a 6mm substrate only. Unlike the standard tap hole template, there is no recess under the concrete as this is not necessary with this thinner worktop.
Use a 32mm hole saw for installation. Push the tap hole template through the hole in the cement fibreboard from the bottom until the bottom ring touches the bottom of the board. Check that the top of the recess is level with the top of the edge profiles.
It is advisable to make the tap hole in the middle between the sink opening and the back wall, so that there is more concrete around the tap hole. If you have a deeper countertop or smaller sink, make sure the faucet is properly aligned above the sink and there is enough concrete to properly mount the faucet.
