Description
Reusable silicone tap hole mold – 35mm
The most common tap hole diameter is 35mm. Provides a 63mm recess 25mm below the surface of the blade to secure the tap.
- For use with standard 57mm profiles and a 12.5 surface.
- For “EuroForm” edge profiles use EuroForm tap hole template.
Use a 68mm hole saw for installation. Push the tap hole template from the bottom through the hole of the cement fiber board until the 3rd ring touches the bottom of the board. Check whether the top of the recess is flush with the top of the edge profiles. It is advisable to make the tap hole in the middle between the sink opening and the back wall, so that there is more concrete around the tap hole. If you have a deeper countertop or smaller sink, make sure the faucet is properly aligned above the sink and there is enough concrete to properly mount the faucet.
